| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002VHU008X |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL (2008 Sequoia) | ||
REMOVAL
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing
.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE COWL SIDE TRIM BOARD LH
4. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
5. REMOVE FRONT PILLAR GARNISH LH
6. REMOVE INSTRUMENT SIDE PANEL LH
7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
11. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
12. REMOVE REAR CONSOLE BOX POCKET
13. REMOVE CONSOLE BOX CARPET
14. REMOVE REAR CONSOLE BOX ASSEMBLY
15. REMOVE FRONT CONSOLE BOX
16. REMOVE AIRBAG SENSOR ASSEMBLY
CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
(a) Pull the lever down and detach the connector holder.
|
(b) Remove the 3 bolts and remove the airbag sensor. |
|
|